[. . . ] € Insulate unconnected wires with vinyl tape or other similar material. To prevent a short circuit, do not remove the caps on the ends of the unconnected wires or the terminals. € If the console has a lid, make sure to install the unit so that the faceplate will not hit the lid when closing and opening. [. . . ] Parking sensor wire (Light Green) PRK SW For the sake of safety, be sure to connect the parking sensor. Connect to vehicle's reverse lamp harness when using the optional rear view camera. To steering remote To use the steering wheel remote control feature, you need to an exclusive remote adapter (not supplied) matches your car is required. To car light control switch Connect to the terminal that is grounded when either the telephone rings or during conversation. To connect the Kenwood navigation system, consult your navigation manual. Depending on what antenna you are using, connect either to the control terminal of the motor antenna, or to the power terminal for the booster amplifier of the film-type antenna. When using the optional power amplifier, connect to its power control terminal. " terminal of the amplifier having the external amp control function. Reveres sensor wire (Purple/White) Steering remote control input (Light Blue/Yellow) Dimmer control wire (Orange/White) Mute wire (Brown) Motor antenna control wire (Blue) Power control wire (Blue/White) External amplifier control wire (Pink/Black) If no connections are made, do not let the cable come out from the tab. CONT + To front right speaker + To rear left speaker Purple/Black P CONT Purple + To rear right speaker EXT. Accessory 2 Accessory 3 Accessory 4 AV OUT ■ Audio/Video Output • Video output (Yellow) • Audio left output (White) • Audio right output (Red) ■ Audio/Video Input1 • Video input (Yellow) • Audio left input (White) • Audio right input (Red) ■ Rear View Camera Input • Video input (Yellow) ■ Front Preout • Audio left output (White) • Audio right output (Red) ■ Rear Preout • Audio left output (White) • Audio right output (Red) ■ Subwoofer Preout • Audio left output (White) • Audio right output (Red) RELAY 2 RELAY 1 SUB WOOFER REAR FRONT REAR VIEW CAMERA AV IN1 To Relay Box 6 | DNX7120/DDX712/DDX7032 DNX_DDX7_insta_K_En_r1. 31 1:34:43 PM Optional Accessory Connection iPod (commercially available) To GXM30/ GTM10 When connecting the XM Tuner GXM30 (optional accessory) or TMC Tuner GTM10 (optional accessory), put the cable clamper (accessory $) to the back of this unit first, and then wire the cable through the clamper. Audio Output (Black) Audio Input KCA-iP300V (Optional Accessory) Accessory 5 Video Output (Yellow) Video Input Accessory $ USB terminal USB terminal To SIRIUS Satellite Radio tuner/ XM Satellite Radio tuner/ HD Radio tuner/KCA-BT200 (Optional Accessory) Conversion adapter (Optional Accessory) may be necessary for connection of Optional Accessory. Navigation System Input (DDX712/DDX7032 only) TV Tuner (Optional Accessory) TV ANTENNA INPUT Navigation System (Optional Accessory) Connection cable (Included in the TV tuner) Connection cable (Included in the Navigation System) DNX_DDX7_insta_K_En_r1. [. . . ] Engage the catch pins on the removal tool 6 and remove the two locks on the lower level. Remove the hard rubber frame by referring to the removal procedure in the section <Removing the Hard Rubber Frame>. Remove the Hex-head screw with integral washer (M4 × 8) on the back panel. [. . . ]